Step Area Chart


A step area chart is an area chart in which points are connected by horizontal and vertical line segments, looking like steps of a staircase. The area between the line segments and the X-axis is filled with color or a pattern.

Step area charts are used when it is necessary to highlight the irregularity of changes: for example, when changes in tax rates or interest rates are visualized. While the basic area chart shows both the trend in data and the magnitude of change over time, the step area chart draws attention from the trend to show periods with no change and emphasize the exact time of each change (as well as its magnitude).

The Step Area and Area chart types share almost all the settings, so this article explains just how to create a basic Step Area chart and configure its only special setting - step direction. To learn about other settings, read the Area Chart article. You can also see the table below to get a brief overview of the Step Area chart's characteristics:

ModulesCore + Basic Cartesian / Base
Data Fieldsx, value
Multiple SeriesYES
StackedStacked Step Area, Percent Stacked Step Area
VerticalVertical Step Area
Error BarsStep Area Chart with Error Bars
StockStock Step Area
Spline Area
Range Area
Range Spline Area
Range Step Area
Chartopedia: Step Area Chart
General Settings


The Step Area chart requires adding the Core and Basic Cartesian modules:

<script src=""></script>
<script src=""></script>

Alternatively, you can use the Base module, which includes, among other things, the two modules mentioned above:

<script src=""></script>

Learn more: Modules.

Quick Start

To create a Step Area series, use the stepArea() method (before, of course, you should create a chart by using anychart.area() or any other cartesian chart constructor):

// create data
var data = [
  {x: "1995", value: 0.10},
  {x: "1996", value: 0.10},
  {x: "1997", value: 0.12},
  {x: "1998", value: 0.13},
  {x: "1999", value: 0.15},
  {x: "2000", value: 0.15},
  {x: "2001", value: 0.15},
  {x: "2002", value: 0.19},
  {x: "2003", value: 0.20}

// create a chart
chart = anychart.area();

// create a step area series and set the data
var series = chart.stepArea(data);

// set step direction to the forward mode

// set the container id

// initiate drawing the chart



The Step Area chart is a modification of the Area chart, so these two types share almost all the settings. You can find more settings in this article: Area Chart.

Also, in AnyChart there are many settings that are configured in the same way for all chart types, including the Step Area chart (for example, legend and interactivity settings): General Settings.

In addition, see the full list of methods available for the Step Area series: anychart.core.cartesian.series.StepArea.

Special Settings

Step Direction

The Step Area chart is formed by horizontal line segments of the same width as the category, connected with each other by vertical segments. To set the exact way these segments are placed, use this method: stepDirection().

There are three modes of step direction: center, backward, and forward. The default mode is center (in this case data points are placed to the center of horizontal segments).

In the forward mode data points are the starting points of horizontal segments:

// set step direction to the forward mode


The backward mode sets data points as the final points of horizontal segments:

// set step direction to the backward mode